TORQUE CONVERTER REPLACEMENT/REPAIR - continued

TM 10-3930-673-34

(3)

Remove parts (29, 30, and 31),

stator (32), and disassemble parts

(33 through 37).

(a)

Remove outer thrust washer (29),

needle thrust bearing (30), inner

thrust washer (31), and stator (32)

from impeller (18).

WARNING

Use care when removing snap and

retaining rings. Snap and retaining

rings are under spring tension and

TR00190

can act as projectiles when released

and could cause severe eye injury.

(b)

Remove two retaining rings (33), two clutch retainers (34), inner race (35), sprag clutch (36),

and outer race (37).

(4)

Remove parts (38 through 40),

impeller hub (41), and parts

(44 and 45).

(a)

Remove outer thrust washer (38),

needle thrust bearing (39), and

inner thrust washer (40) from

impeller hub (41).

(b)

Remove eight screws (42),

washers (43), and impeller hub (41)

from impeller (18).

(c)

Remove preformed packing (44) and

seal ring (45). Discard preformed

packing.

c. Cleaning. See Cleaning Instructions

(Para 2-12).

TR00191

d. Inspection. See Inspection Instructions

(Para 2-14).

e. Assembly.

NOTE

Wipe all sealing surfaces clean and dry. Apply a thin film of clean hydraulic oil to all

seals and bearings as they are installed.

(1)

Install parts (44 and 45), impeller hub (41), and parts (38 through 40).

7-5