CAB WIRING HARNESS REPLACEMENT/REPAIR

TM 10-3930-673-34

6-5. CAB WIRING HARNESS REPLACEMENT/REPAIR

This Task Covers:

a. Removal

b. Inspection

c. Installation

INITIAL SETUP

Materials/Parts

Tools and Special Tools

Lockwashers (10)

Tool Kit, General Mechanic's: Automotive

Lockwashers (6)

Lockwasher

Shop Equipment, Automotive Maintenance,

Lockwashers (4)

Common No. 2 Less Power

Equipment Condition

Negative Battery Cable disconnected

(TM10-3939-673-20)

a. Removal.

NOTE

Tag all electrical leads as removed for use during installation.

(1)

Unplug forty-four female connectors (2) from male connectors (1).

(2)

Disconnect wires from six lamp holders (3).

(3)

Disconnect eighteen connectors (4), twenty-seven connectors (5), connector (6), six

connectors (7), thirty-four connectors (8), and eleven connectors (9) from devices

indicated.

(4)

Disconnect two connectors (10) from steer select valve.

(5)

Remove fourteen nuts (11), ten lockwashers (12), six lockwashers (13), nut (14),

lockwasher (15), five flat washers (16), twelve clamps (17), and four lockwashers (18).

Discard lockwashers.

(6)

Remove cable clamps (19-21) and disconnect connectors (22 through 25).

(7)

Carefully push out two grommets (26) and grommet (27) from front harness section (28).

(8)

Remove front harness section (28).

(9)

Disconnect seven terminals (29) from devices indicated. Remove rear wire harness

section (30) and grommet (27).

6-19