3-25. ENGINE OIL PUMP REPLACEMENT (CONT)
Lips of oil seal in gear cover and seal
surface on crankshaft end must be
clean and free of oil. Failure to
properly clean sealing surfaces may
cause oil to leak at oil seal.
Install gear cover (9).
When installing gear cover be
careful not to damage lips of oil seal.
Failure to protect oil seal lips during
installation of oil seal over
crankshaft end may damage oil seal
lips and cause leakage.
Install pilot tool from seal kit inside
diameter of oil seal to protect oil seal
lips during gear cover (9)
Install gasket (14) and gear cover (9) on engine block.
Remove pilot tool from seal bore.
Install eight screws (13) and 11 screws (12) in gear cover (9).
Tighten screws hand tight.
Install belt guide (11) and screws (10). Tighten screws (10, 12, and 13) to 216 lb-in
Install tachometer drive (TM 10-3930-673-20).