Screws which retain the gear
housing and cover are of three sizes.
Note sizes and locations of screws
during removal to ensure proper
Remove screw (3) and belt guide (4).
Remove eight screws (5) and 11
screws (6) from gear cover (7).
Remove gear cover (7) and gasket (8)
from gear housing (9). Discard
Remove camshaft and timing gear
Remove fuel injection pump
Remove two screws (10) and five
screws (11) from gear housing (9).
Remove gear housing (9) and
gasket (12) from cylinder block (13).
Use a gasket scrapper to remove old
gasket material from cylinder
block (13) and gear housing (9).
If damaged, using a suitable puller
or driver remove oil seal (14) from
gear cover (7).
Use care when removing snap and
retaining rings. Snap and retaining
rings are under spring tension and
can act as projectiles when released
and could cause severe eye injury.
Remove two screws (15), housing (16), preformed packings (17 and 18), timing pin (19),
and retaining ring (20) as an assembly from gear housing (9). Discard preformed