 |
|||
|
|
|||
|
Page Title:
CRANKSHAFT REAR SEAL REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 10-3930-673-34
(2)
Remove rear crankshaft oil seal (1)
with slide hammer dent puller.
(a)
Insert a #10 sheet metal screw into
end of slide hammer dent puller.
(b)
Alternately put slide hammer dent
puller into the two 1/8 in. (3.175
mm) drilled holes and pull until oil
seal (1) is removed. Discard rear oil
seal.
TR01035
b. Installation.
CAUTION
The seal lip and sealing surface on
crankshaft must be clean to help
prevent an oil leak around the seal.
(1)
Clean oil seal (1) lip and sealing
surface on crankshaft with clean
wiping rags.
TR01036
(2)
Install seal pilot (2) supplied with
seal kit onto crankshaft.
CAUTION
Always use the seal pilot to install
rear oil seal (1). Failure to do so
could result in a damaged oil seal.
(3)
Install oil seal (1) over seal pilot (2)
and onto crankshaft.
(4)
Remove seal pilot (2) from
crankshaft.
TR01037
3-91
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals