3-10. CRANKSHAFT FRONT SEAL REPLACEMENT (CONT)
The seal lip and sealing surface on
crankshaft must be clean to help
prevent an oil leak around the seal.
Clean oil seal (1) lip and sealing
surface on crankshaft with clean
The seal and seal pilot used in
Step (2) are packaged as a single
item. Do not separate these two
components before seal installation.
Failure to use the pilot could result
in a damaged seal.
Install oil seal (1) and seal pilot (2)
Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors,
and are harmful to skin and clothing. To avoid injury or death, keep away from open fire
and use in a well-ventilated area. If adhesive, solvent, or sealing compound gets on skin
or clothing, wash immediately with soap and water.
Apply a bead of sealing compound around outside surface of oil seal (1).
Push on oil seal (1) until oil seal is inside gear cover then remove seal pilot (2).