Be careful not to damage or scratch the crankshaft during removal.
Attach lifting straps to a suitable hoist. Slowly and carefully lift crankshaft (16) from the
cylinder block (4).
Place crankshaft (16) in a clean, dry work area.
Remove upper bearing halves (18) and thrust bearing (19).
Remove upper bearing halves (18) from main bearing positions (1 through 5 and 7) in cylinder
Remove thrust bearing (19) from no. 6 main bearing location in cylinder block (4).
Remove wear sleeves (20 and 21) if
installed or necessary.
Remove and discard front wear
sleeve (20) and rear wear sleeve (21) from
Remove crankshaft gear (22).
Use a suitable gear puller to remove
crankshaft gear (22) and roll pin (23), if
necessary, from crankshaft (16).