3-7. CYLINDER HEAD ASSEMBLY REPLACEMENT/REPAIR (CONT)
Tap valve stems lightly to seat
Repeat Steps (a) through (e) for
remainder of valves.
Install engine lifting brackets
The bottom surface of cylinder head
and top of cylinder block must be
clean of all residue and dry. Dirty
surfaces could cause leaks or
incorrect seat between cylinder
head and block.
Install gasket (7).
Install gasket (7) over cylinder block
dowels (16). Be sure gasket is correctly
aligned with holes in block.
Place cylinder head (2) on block (17).
The cylinder head weighs 114 lb
(51.71 kg). Attach suitable lifting
device prior to installation to
prevent possible injury to personnel.
Attach lifting chains and hoist (or
other suitable lifting device) to engine lifting brackets.
Carefully place cylinder head (2) over block dowels (16) and on block (17).
Remove lifting chains and hoist.