Installation - continued - TM-10-3930-673-340137

TM 10-3930-673-34

WARNING

Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors,

and are harmful to skin and clothing. To avoid injury or death, keep away from open fire

and use in a well-ventilated area. If adhesive, solvent, or sealing compound gets on skin

or clothing, wash immediately with soap and water.

NOTE

When installing cup plugs, apply sealing compound.

(4)

Install three new cup plugs (6) in cylinder block (3) oil passages.

(a)

Apply a bead of sealing compound to entire circumference of each new cup plug (6).

(b)

Using a drift and a hammer, install cup plugs (6) with convex side out and until outer edges

are flush with countersink in cylinder block (3).

(5)

Install one pipe plug (5) and two pipe plugs (4) in cylinder block (3).

WARNING

Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors,

and are harmful to skin and clothing. To avoid injury or death, keep away from open fire

and use in a well-ventilated area. If adhesive, solvent, or sealing compound gets on skin

or clothing, wash immediately with soap and water.

(a)

Apply small amount of sealing compound to threads of all three pipe plugs (5 and 4).

(b)

Install pipe plugs (4 and 5) and tighten to 120 lb-in (12.56 Nm).

(6)

Install camshaft expansion plug (2).

WARNING

Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors,

and are harmful to skin and clothing. To avoid injury or death, keep away from open fire

and use in a well-ventilated area. If adhesive, solvent, or sealing compound gets on skin

or clothing, wash immediately with soap and water.

(a)

Apply a bead of sealing compound to entire circumference of each expansion plug (2).

(b)

Place expansion plug (2) in bore with convex side out.

(c)

Drive against convex side of expansion plug (2) using a large drift and a hammer to expand

plug. Continue to drive against convex side of plug until convex side of plug is flush with face

of cylinder block.

3-35