Machined Surfaces.

TM 10-3930-673-34

fresh air and medical help. If solvent contacts skin or clothes, flush with cold water. If

solvent contacts eyes, immediately flush eyes with water and get immediate medical

attention.

Improper cleaning methods and use of unauthorized cleaning solvents may injure

personnel and damage equipment. Refer to TM9-247 for correct information.

Eye shields must be worn when cleaning with a wire brush. Flying rust and metal

particles may cause injury to personnel.

Particles blown by compressed air are hazardous. Make certain the air stream is

directed away from user and other personnel in the area. To prevent injury, user must

wear protective goggles or face shield when using compressed air.

(1)

Clean machine tooled parts with dry cleaning solvent (P-D-680).

(2)

Dry parts with compressed air.

i. Machined Surfaces.

WARNING

Drycleaning Solvent (P-D-680) is TOXIC and flammable. Wear protective goggles and

gloves; use only in a well-ventilated area; avoid contact with skin, eyes, and clothes;

and do not breathe vapors. Keep away from heat or flame. Never smoke when using

solvent; the flashpoint for type I drycleaning solvent is 100F (38C), type II is 138F

(59C), and type III is 200F (93.3C). Failure to do so may result in injury or death to

personnel. If personnel become dizzy while using cleaning solvent, immediately get