If an individual wire is broken, it is not
necessary to replace entire wiring
harness. Refer to step c. Repair for wire
Open left engine compartment door (TM
Remove nut (1), external tooth
lockwasher (2), and ring terminal of wire
no. 2 (3) of arctic heater wiring harness
(4) from ground stud (5). Leave existing
cable or wires in place. Discard
Remove nut (6), external tooth
lockwasher (7), and ring terminal of wire
no. 9 (8) from screw (9) of "L" shaped
copper terminal (10) on starter (11).
Leave existing cables in place. Discard
· Remove tie wraps as necessary.
· Note routing of wiring harness for ease