18-24. BOOM HYDRAULIC HOSE AND ELECTRICAL CABLE TENSION ADJUSTMENT
Check tension of three boom hydraulic hoses
(5 through 7) and boom electrical cable (8).
Ensure that boom hydraulic hoses and
boom electrical cable are not crossed
inside boom and are routed properly over
hose tension plate and pulley at rear of
Check hydraulic hoses (5 through 7) at
pulley assembly (9) and at cylindrical
lead (10) welded on underside of boom
(1) for slack.
Pull on boom electrical cable (8) at pulley
assembly (9) and at cylindrical lead (10)
to check for slack in cable (8).
If slack is found in Steps (3)(a) and/or
(3)(b) above, perform Step (4) below to