Installation - TM-10-3930-673-20-20617

TM 10-3930-673-20-2

(b)

Remove locknut (11) and screw (12) from

cylinder pivot pin (13). Discard locknut.

WARNING

Use caution when driving pin out of

attachment and cylinder to prevent injury

to personnel.

(c)

Remove cylinder pivot pin (13) from

attachment (10.1), boom (2), and cylinder

(3) 1/2 way (just past cylinder) (Do not

exceed 16 inches).

NOTE

Note quantity of shim washers for

installation.

TR00856

(c.1) Remove one or more shim washers (13.1)

from between attachment (10.1) and

boom (2).

(c.2) Operate vehicle and retract cylinder (3) to allow access to hoses (7 and 8).

(c.3) Tag, mark, and remove two hoses (7 and 8) from elbows (9 and 10).

(d)

Using suitable lifting device and lifting strap, lower cylinder (3) to ground.

(5)

Support carriage tilt cylinder (3) with

suitable sling and hoist.

(6)

Remove carriage tilt cylinder (3) from

attachment (10.1).

(7)

Remove two elbows (9 and 10), adapters (14

and 15), and preformed packings (16 and 17)

from cylinder (3). Discard preformed

packings.

(8)

Remove grease fitting (18) from each end of

carriage tilt cylinder (3).

b. Installation.

(1)

Install grease fitting (18) on each end of

TR00855

carriage tilt cylinder (3).

(2)

Install two preformed packings (16 and 17),

adapters (14 and 15), and elbows (9 and 10)

in cylinder (3).

Change 1

18-83