Connect four hydraulic hoses (1 through 4)
on fittings (5 through 8).
Connect four hydraulic hoses (1 through
4) on three adapters (5, 6, and 7) and
Install cover (10) on side console (11)
with four screws (9).
Any time hydraulic oil has been drained
and changed or maintenance has been
performed on hydraulic system, it is
possible that hydraulic pumps have air in
pump cavities. Air must be purged from
cavities before pump will operate. (Refer
to Para 18-2).
Bleed air from frame tilt circuit.
Start engine (TM 10-3930-673-10).
Operate frame tilt function and tilt vehicle
from side to side five times.
Stop engine and relieve hydraulic
pressure by operating frame tilt controls
END OF TASK