14-6. STEERING HOSES AND FITTINGS REPLACEMENT (CONT)
Tag, mark, and remove hydraulic hoses (1),
fittings (2), and preformed packings (3)
from hydraulic components (4).
Remove hoses (1) from fittings (2).
Rear axle has two more tee fittings than
front axle. Rear axle is shown.
Remove fittings (2) and preformed
packings (3) from hydraulic components
(4). Discard preformed packings.
Note location of clamps for use during
Remove clamps (5) and mounting hardware
(6) from hydraulic hoses (1).
Note routing of hoses on vehicle for ease
Remove hydraulic hoses (1) from vehicle
· Apply light coating of clean hydraulic oil to all seals as they are installed.
· Hydraulic lines must be mounted to allow movement of lines during steering without rubbing or
· Apply thin coat of loctite to threads of mounting hardware screws at installation.
Position hydraulic hoses (1) on vehicle frame (7).