0-1. SERVICE BRAKE PADS INSPECTION/REPLACEMENT (CONT)
Using suitable piece of wood levered
against brake pads (1), push pistons (6)
completely into brake caliper (2).
Tighten two bleeder valves (5).
Remove brake pads (1) from brake caliper
Inspect brake pads (1).
Inspect brake pads (1) for wear. Replace
if lining thickness is less than 1/8 in. (3.2
If linings are worn unevenly, check
pistons for correct operation. If pistons
are locked in piston bore, or rotor surface
is not flat and parallel to linings, notify
Direct Support Maintenance.
Inspect brake pads (1) for uneven wear.
Replace pads if thickness varies between