LINE TO FUEL
(1) Check for contaminated fuel by
operating engine with known clean fuel
from temporary supply tank.
(a) Disconnect fuel line at fuel/water
separator, where line leads to fuel
(b) Place disconnected end of fuel line
in temp tank of known clean fuel.
(c) Start engine and run it for
approximately 5 minutes to
determine if engine performance
improves with known clean fuel.
(2) If fuel in fuel tank proves clean, refer to
the Electrical Troubleshooting Section
(3) If fuel in fuel tank is contaminated, shut
(TM 10-3930-673-10), drain and flush
tank, and replace fuel with clean fuel
LINES O FUEL/WATER