 |
|||
|
|
|||
|
Page Title:
FUEL GAGE DOES NOT OPERATE - continued |
|
||
| ||||||||||
|
|
 TM 10-3930-673-20-1
INSTRUMENT FUEL
SCREW
PANEL
GAGE
VOLTAGE TEST
(1) Set multimeter to volts dc.
(2) Connect multimeter positive lead (+) to
fuel gage where wire 12 connects.
(3) Connect multimeter negative lead () to
known good ground.
(4) Connect negative battery cable to
negative side of battery (Para 8-42).
(5) Turn engine start switch to ON position,
BUT DO NOT START ENGINE
(TM 10-3930-673-10).
(a) If voltage is present, go to Step 4
of this fault.
(b) If voltage is not present, replace
fuel gage (Para 8-6).
(6) Turn engine start switch to OFF
position (TM 10-3930-673-10).
(7) Disconnect negative battery cable from
negative side of battery (Para 8-42).
ENGINE START
SWITCH
VOLTAGE TEST
(1) Set multimeter to volts dc.
(2) Remove four screws and cap from fuel
WIRE 12
level transducer.
(3) Connect multimeter positive lead (+) to
fuel level transducer where wire 12
connects.
(4) Connect multimeter negative lead () to
known good ground.
(5) Connect negative battery cable to
negative side of battery (Para 8-42).
(6) Turn engine start switch to ON position,
BUT DO NOT START ENGINE
TRANSDUCER
(TM 10-3930-673-10).
(a) If voltage is present, replace fuel
level transducer (Para 8-38).
(b) If voltage is not present, go to
WIRE 12
Step 5 of this fault.
(7) Turn engine start switch to OFF
position (TM 10-3930-673-10).
(8) Disconnect negative battery cable from
negative side of battery (Para 8-42).
(9) Install cap and four screws for fuel level
transducer.
TR01545
2-547
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals