(1) Set multimeter to volts dc.
(2) Connect multimeter positive lead (+) to
joystick terminal board pin for
(3) Connect multimeter negative lead () to
known good ground.
(4) Connect negative battery cable to
negative side of battery (Para 8-42).
(5) Turn engine start switch to ON position,
BUT DO NOT START ENGINE
(a) If voltage is present, go to Step 5
of this fault.
(b) If voltage is not present, go to
Step 4 of this fault.
(6) Turn engine start switch to OFF
position (TM 10-3930-673-10).