Quantcast REAR WINDSHIELD WIPERS DO NOT OPERATE - continued - TM-10-3930-673-20-10471

 

Click here to make tpub.com your Home Page

Page Title: REAR WINDSHIELD WIPERS DO NOT OPERATE - continued
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

Share on Google+Share on FacebookShare on LinkedInShare on TwitterShare on DiggShare on Stumble Upon
Back
REAR WINDSHIELD WIPERS DO NOT OPERATE - continued - TM-10-3930-673-20-10470
Up
TM-10-3930-673-20-1 All Terrain Lifter Army System (ATLAS) 10 000 lb Capacity Manual
Next
REAR WINDSHIELD WIPERS DO NOT OPERATE - continued - TM-10-3930-673-20-10472
TM 10-3930-673-20-1
VOLTAGE CHECK
(1) Set multimeter to volts dc.
(2) Connect multimeter positive lead (+) to
wire 33 where wire 33 connects to rear
wiper switch.
(3) Connect multimeter negative lead () to
known good ground.
(4) Connect negative battery cable to
negative side of battery (Para 8-44).
(5) Turn engine start switch to ON position,
BUT DO NOT START ENGINE
(TM 10-3930-673-10).
(6) Turn rear wiper switch to HI position
(TM 10-3930-673-10).
(a) If 24 vdc is present, go to Step 3 of
this fault.
(b) If 24 vdc is not present, replace
rear wiper switch (Para 8-7).
(7) Turn rear wiper switch to OFF position
(TM 10-3930-673-10).
(8) Turn engine start switch OFF
(TM 10-3930-673-10).
(9) Disconnect negative battery cable
(Para 8-44).
VOLTAGE CHECK
(1) Set multimeter to volts dc.
(2) Connect multimeter positive lead (+) to
wire 34 where wire 34 connects to rear
ENGINE START
wiper switch.
SWITCH
WIRE 33
(3) Connect multimeter negative lead () to
known good ground.
(4) Connect negative battery cable to
negative side of battery (Para 8-44).
(5) Turn engine start switch to ON position,
WIRE 34
BUT DO NOT START ENGINE
(TM 10-3930-673-10).
REAR WIPER
(6) Turn rear wiper switch to LO position
SWITCH
(TM 10-3930-673-10).
(a) If 24 vdc is present, go to Step 4 of
TR01156
this fault.
(b) If 24 vdc is not present, replace
rear wiper switch (Para 8-7).
(7) Turn rear wiper switch to OFF position
(TM 10-3930-673-10).
(8) Turn engine start switch OFF
(TM 10-3930-673-10).
(9) Disconnect negative battery cable
(Para 8-44).
2-419

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc.