 |
|||
|
|
|||
|
Page Title:
ALL TURN SIGNALS DO NOT OPERATE - continued |
|
||
| ||||||||||
|
|
 TM 10-3930-673-20-1
VOLTAGE TEST
(1) Disconnect negative battery cable from
negative side of battery (Para 8-42).
(2) Set multimeter to volts dc.
(3) Disconnect wire 27 or 28 from turn
signal switch.
(4) Connect multimeter positive lead (+) to
male blade connector of wire 27 or
wire 28.
(5) Connect multimeter negative lead () to
known good ground.
(6) Connect negative battery cable to
negative side of battery (Para 8-42).
(7) Turn engine start switch to ON position,
BUT DO NOT START ENGINE
(TM 10-3930-673-10).
(8) Turn on turn signal for appropriate turn
signal wire (right wire 28, left wire 27
WIRE 28
[TM 10-3930-673-10]).
(a) If 24 vdc is present, repair wire 27
or wire 28.
(b) If 24 vdc is not present, replace
turn signal switch (Para 8-12).
WIRE 27
(9) Turn engine start switch to OFF
position (TM 10-3930-673-10).
(10) Disconnect negative battery cable from
TR01728
negative side of battery (Para 8-42).
(11) Connect wire 27 or 28 to turn signal
switch.
(12) Install access panel and four screws.
(13) Connect negative battery cable to
negative side of battery (Para 8-42).
(14) Install battery cover (Para 8-42).
2-211
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals