 |
|||
|
|
|||
|
Page Title:
ALL TURN SIGNALS DO NOT OPERATE - continued |
|
||
| ||||||||||
|
|
 TM 10-3930-673-20-1
VOLTAGE TEST
CIRCUIT BREAKER CB10
(1) Disconnect negative battery cable from
negative side of battery (Para 8-42).
(2) Set multimeter to volts dc.
(3) Connect multimeter positive lead (+) to
circuit breaker CB10 where wire 24
connects.
(4) Connect multimeter negative lead () to
known good ground.
(5) Connect negative battery cable to
negative side of battery (Para 8-42).
WIRE 24
(6) Turn engine start switch to ON position,
BUT DO NOT START ENGINE
(TM 10-3930-673-10).
(a) If 24 vdc is present, go to Step 11
of this fault.
(b) If 24 vdc is not present, replace
circuit breaker CB10 (Para 8-11).
(7) Turn engine start switch to OFF
position (TM 10-3930-673-10).
(8) Disconnect negative battery cable from
negative side of battery (Para 8-42).
VOLTAGE TEST
(1) Set multimeter to volts dc.
(2) Connect multimeter positive lead (+) to
turn signal flasher where wire 24
connects.
(3) Connect multimeter negative lead () to
known good ground.
(4) Connect negative battery cable to
TURN SIGNAL
F
negative side of battery (Para 8-42).
LASHER
(5) Turn engine start switch to ON position,
BUT DO NOT START ENGINE
WIRE 24
(TM 10-3930-673-10).
(a) If 24 vdc is present, go to Step 12
of this fault.
(b) If 24 vdc is not present, repair wire
24 (Para 8-48).
(6) Turn engine start switch to OFF
position (TM 10-3930-673-10).
(7) Disconnect negative battery cable from
TR01726
negative side of battery (Para 8-42).
2-207
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals