Quantcast ONE OR BOTH HEADLIGHTS DO NOT OPERATE - continued - TM-10-3930-673-20-10183

 

Click here to make tpub.com your Home Page

Page Title: ONE OR BOTH HEADLIGHTS DO NOT OPERATE - continued
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

Share on Google+Share on FacebookShare on LinkedInShare on TwitterShare on DiggShare on Stumble Upon
Back
ONE OR BOTH HEADLIGHTS DO NOT OPERATE - continued - TM-10-3930-673-20-10182
Up
TM-10-3930-673-20-1 All Terrain Lifter Army System (ATLAS) 10 000 lb Capacity Manual
Next
ONE OR BOTH HEADLIGHTS DO NOT OPERATE - continued - TM-10-3930-673-20-10184
TM 10-3930-673-20-1
VOLTAGE TEST
(1) Remove four screws from instrument
SCREW
BLACKOUT
panel.
LIGHT SWITCH
(2) Lift instrument panel out to remove
connector J3 from blackout light switch.
(3) Set multimeter to volts dc.
(4) Connect multimeter positive lead (+) to
connector J3-F where wire 40
connects.
(5) Connect multimeter negative lead () to
known good ground.
(6) Connect negative battery cable to
negative side of battery (Para 8-42).
(7) Turn engine start switch to ON position,
BUT DO NOT START ENGINE
(TM 10-3930-673-10).
(a) If 24 vdc is present, go to Step 11
of this fault.
(b) If 24 vdc is not present, repair
wire 40 (Para 8-48).
(8) Turn engine start switch to OFF
position, (TM 10-3930-673-10).
(9) Disconnect negative battery cable from
ENGINE
negative side of battery (Para 8-42).
START
(10) Lift instrument panel out to connect
SWITCH
connector J3 to blackout light switch.
INSTRUMENT
(11) Install four screws to secure instrument
PANEL
panel.
J3-F
VOLTAGE TEST
CONNECTOR J3
(1) Set multimeter to volts dc.
(2) Disconnect connector J1 from
connector P1.
CONNECTOR P1
(3) Connect multimeter positive lead (+) to
connector J1-2 where wire 49
connects.
(4) Connect multimeter negative lead () to
known good ground.
(5) Connect negative battery cable to
negative side of battery (Para 8-42).
(6) Turn engine start switch to ON position,
BUT DO NOT START ENGINE
J1-2
(TM 10-3930-673-10).
(7) Turn blackout light switch to SER.
DRIVE position (TM 10-3930-673-10).
(a) If 24 vdc is present, go to Step 13
CONNECTOR J1
of this fault.
(b) If 24 vdc is not present, go to
Step 12 of this fault.
(8) Turn blackout light switch to OFF
position (TM 10-3930-673-10).
(9) Turn engine start switch to OFF
position, (TM 10-3930-673-10).
(10) Disconnect negative battery cable from
negative side of battery (Para 8-42).
TR01743
2-131

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc.