TM 10-3930-671-24 F. Clutch Disassembly (Forward & Reverse Clutch Procedure Are the Same) Reverse Shown Being Disassembled 1. Remove   outer   clutch   hub   gear   thrust   bearing and  thrust  washers,  clutch  hub  gear,  and  inner clutch hub thrust bearing and thrust washers. 2. Disassemble  the  two  clutch  gear  bearings  and spacer from internal bore of clutch gear hub. 3. Remove  clutch  disc  end  plate  retainer  ring  and clutch disc end plate. 4. Remove inner and outer clutch discs. 5. Remove clutch return spring retainer ring. 6. Remove clutch return (release) springs (Belleville washers). Note assembly arrangement. 7. Remove clutch piston wear plate. 8. Remove  clutch  piston  by  turning  clutch  upside down and tapping the shaft on a block of wood. 9. Remove and discard clutch piston sealing rings. 10. Repeat    procedures,    Steps    1    through    9,    for forward clutch disassembly. G. Differential Disassembly 1. Use   a   small   drift   pin   or   rod   to   remove   the differential pinion pin lock pin. 2. Remove the pinion pin. 3. Rotate the pinion gears and washers  to  remove them from the differential housing. F-364