TM 10-3930-671-24 (15) To remove valve mounting bracket (75), proceed as follows: (a) Remove hydraulic oil filter base assembly (Para 3-33). (b) Remove two nuts (92), washers (93), screws (94), and valve mounting bracket (75) from forklift (5). (16) To remove cover plate (95), proceed as follows: (a) Remove radiator cap cover (96) from cover plate (95). (b) Remove four screws (97), cover plate (95), and four fasteners (98) from forklift (5). (c) Remove seal (99) from cover plate (95). b. Installation. (1) To install cover plate (95), proceed as follows: (a) Install seal (99) on cover plate (95). (b) Install cover plate (95) on forklift (5) with four screws (97) and four fasteners (98).  Tighten screws 30-35 lb-ft (40- 50 N•m). (c) Install radiator cap cover (96) on cover plate (95). (2) Install  valve  mounting  bracket  (75)  on  forklift  (5)  with  two  screws  (94),  washers  (93),  and  nuts  (92).    Tighten screws 30-35 lb-ft (40-50 N-m). (3) Install hydraulic oil filter base assembly (Para 3-33). NOTE The  procedure  to  install  brackets  is  the  same  for  both  left  and  right  hinge  brackets.    Right-side hinge bracket is shown. (4) Install hinge bracket (89) on forklift (5) with two fasteners (91), screws (90), and hinge bracket (89). (5) To install front assembly plate (70), proceed as follows: (a) Install latch stud (88) on front assembly plate (70) with two nuts (86) and washers (87). (b) Install two button plugs (85) on front assembly plate (70). (c) Install front assembly plate (70) on forklift (5) with latch stud (82), two nuts (83), washers (84), screws (78), screws (79), nuts (80), and nuts (81).  Tighten screws (71) 30-35 Ib-ft (40-50 N•m) and screws (72) 53-59 Ib- ft (72-80 N•m). (d) Install master power switch (77) on front assembly plate (70) (Para 3-22, Step a(2)[a]). (6) Install plate (74) with rubber mat (71) on valve mounting bracket (75) with two screws (73) and nuts (72).  Tighten nuts 30-35 Ib-ft (40-50 N•m). (7) Install cover (68) on front assembly plate (70) with four screws (69).  Tighten screws 180-220 lb-in (20-25 N•m). 3-103