| |
TM 10-3930-669-34
CAUTION
Make sure that no parts tilt or slide
out of position while installing spool
and sleeve assembly. Keep pin in
horizontal position. Do not push end
of spool and sleeve assembly past
end of housing. Damage to spool
and sleeve assembly or housing may
result if these precautions are not
followed.
(9)
Install two preformed packings (20 and 19) in
gland bushing (13).
(10)
Install preformed packing (18) on spool and
sleeve assembly (17) and carefully install spool
and sleeve assembly into control pump housing
(1), with a slight rotating movement, until end of
assembly is flush with end of housing. Make
sure spool rotates freely with slight fingertip
pressure at splined end.
(11)
Install bearing race (16), needle thrust bearing
(15), and bearing race (14).
(12)
Install gland bushing (13) and retaining ring (12).
12-21
|
