TM 10-3930-669-34 b. Cleaning/Inspection. WARNING • Dry-cleaning solvent (P-D-680) is TOXIC and flammable.  Wear protective goggles and gloves; use only  in  a  well-ventilated  area;  avoid  contact  with  skin,  eyes,  and  clothes;  and  do  not  breathe vapors.  Keep away from heat or flame.  Never smoke when using solvent; the flashpoint for type I dry-cleaning solvent is 100°F (38°C) and for type II is 138°F (50°C).  Failure to do so may result in injury or death to personnel. • If  personnel  become  dizzy  while  using  cleaning  solvent,  immediately  get  fresh  air  and  medical help.    If  solvent  contacts  skin  or  clothes,  flush  with  cold  water.    If  solvent  contacts  eyes, immediately flush eyes with water and get immediate medical attention. (1) Clean all parts in dry-cleaning solvent.  Allow to air dry. (2) Inspect bearings and bearing cups for scratches, cracks, glazing, rust pitting, flat spots, and other wear. (3) Inspect tie rod arm for wear and damage. (4) Inspect steering cylinder for any evidence of external damage. (5) Replace damaged parts or notify supervisor. c. Installation. (1) Install left and right tie rod arms (4 and 5) on   steering   cylinder   (10)   with   two   pins (17), washers (16), and cotter pins (15). 12-7