TM 10-3930-669-34 WARNING Use care when removing or installing snap and retaining rings.  Snap and retaining rings are under spring tension and can act as projectiles when released and could cause severe eye injury. (14) Coat thrust washer (24) and retaining ring (23) with clean transmission oil. (15) Install thrust washer (24) and retaining ring (23) on input shaft (11). (16) Coat input shaft (11) with clean transmission oil. NOTE Rotate input shaft during installation to ensure that tab drops into pump. (17) Install input shaft (11) on pump assembly (22). (18) Coat retaining ring (21), bearing (20), retaining ring (19), seal (18), and shaft (14) with clean transmission oil. (19) Install shaft (14) in bearing (20) with retaining ring (21). (20) Install bearing (20), retaining ring (19), and seal (18) in cover assembly (5). (21) Using a wiping rag, clean excess oil from outside surface of seal (18). 8-31