TM 10-3930-669-34 2-3.  REPAIR PARTS. Repair parts are listed and illustrated in the Repair Parts and Special Tools List, TM 10-3930-669-24P, for maintenance of this equipment. Section II.  SERVICE UPON RECEIPT 2-4.  GENERAL SERVICE INSTRUCTIONS. a. Refer to TM 10-3930-669-10 for operating instructions for the forklift. b. Upon receipt of a new, used, or reconditioned forklift, the receiving organization must see if it has been properly prepared   for   service   and   is   in   good   condition   (TM   10-3930-669-10).      Inspect   all   assemblies,   subassemblies,   and accessories to be sure  they  are  in  proper  working  order.    Secure,  clean,  correctly  adjust,  and/or  lubricate  (LO  10-3930- 669-12) as needed. c. Follow general procedures for all services and inspections given in TM 10-3930-669-10. 2-5.  INSPECTION AND SERVICING EQUIPMENT. NOTE If  forklift  has  been  driven  to  the  using  organization,  most  or  all  of  the  following work should have been done. a. When  forklift  is  received,  inspect  all  items  for  damage  that  may  have  occurred  during  shipping  and  unloading operations.    Pay  close  attention  to  any  loose  or  missing  nuts,  bolts,  screws,  access  plates,  drain  plugs,  draincocks,  oil plugs, assemblies, subassemblies, or components that may have been lost or broken in transit. WARNING • Dry-cleaning  solvent  (P-D-680)  is  TOXIC  and  flammable.    Wear  protective goggles  and  gloves;  use  only  in  a  well-ventilated  area;  avoid  contact  with skin, eyes, and clothes; and do not breathe vapors.  Keep away from heat or flame.    Never  smoke  when  using  solvent;  the  flashpoint  for  type  1  dry- cleaning solvent is 100'F (38°C) and for type II is 138'F (50'C).  Failure to do so may result in injury or death to personnel. • If  personnel  become  dizzy  while  using  cleaning  solvent,  immediately  get fresh air and medical help.  If solvent contacts skin or clothes, flush with cold water.    If  solvent  contacts  eyes,  immediately  flush  eyes  with  water  and  get immediate medical attention. b. Clean all exterior surfaces coated with rust-preventive compound with dry-cleaning solvent. 2-3