TM 10-3930-669-34 b.    Cleaning/Inspection. WARNING • Dry-cleaning  solvent  (P-D-680)  is  TOXIC  and  flammable.    Wear  protective  goggles  and gloves; use only in a well-ventilated area; avoid contact with skin, eyes, and clothes; and do  not  breathe  vapors.    Keep  away  from  heat  or  flame.    Never  smoke  when  using solvent; the flashpoint for type I dry-cleaning solvent is  100°F  (38°C)  and  for  type  II  is 138°F (50°C).  Failure to do so may result in injury or death to personnel. • If  personnel  become  dizzy  while  using  cleaning  solvent,  immediately  get  fresh  air  and medical  help.    If  solvent  contacts  skin  or  clothes,  flush  with  cold  water.    If  solvent contacts eyes, immediately flush eyes with water and get immediate medical attention. • Compressed air used for cleaning purposes will not exceed 30 psi (207 kPa).  Use only with effective chip guarding and personal protective equipment (goggles/shield, gloves, etc.).  Failure to comply may result in injury or death to personnel. (1) Clean all metal parts with dry-cleaning solvent. (2) Inspect all parts for cracks or damage. (3) Replace all damaged parts. c. Installation. WARNING Adhesive sealant MIL-S-46163 can damage your eyes.  Wear safety goggles/glasses when  using;  avoid  contact  with  eyes.    If  sealant  contacts  eyes,  flush  eyes  with water and get immediate medical attention. (1) Apply   sealing   compound   to   all   gasket   mating surfaces  and  position   gasket   (7),   intermediate plate (6) and gasket (5) on engine (1). (2) Install  oil  pan  (2)  on  engine  (1)  with  twenty-one washers (4) and screws (3). (3) Rotate engine (1) until oil pan (2) is on bottom. NOTE Follow-on Maintenance: • Install transmission (Para 8-3). END OF TASK 3-53