| |
TM 10-3930-669-20
11-7. PARKING BRAKE REPLACEMENT (CONT).
(3)
Position two brake pads (16) and
spring (15) in brake caliper (10).
(4)
Position brake caliper (10) on disc (14).
(5)
Position brake caliper (10) inside of
forklift bracket (4) and install two
pins (13) and retaining rings (12).
(6)
Install screw (11), through brake
caliper (10) and spring (15).
NOTE
Steps
(7)
through
(16)
provide
adjustment procedures.
(7)
Loosen retaining screw (24).
(8)
Insert 0.031 in. (0.794 mm) shim
between rear pad (16) and disk (14).
(9)
Rotate rear pad adjuster (25) until two
brake pads (16) are hand tight against
brake disk (14).
(10) Loosen rear pad adjuster (25) until the
nearest flat is positioned below retaining
screw (24).
(11) Tighten retaining screw (24). Remove
0.031 in. (0.794 mm) shim.
11-28
|
