| |
TM 10-3930-669-20
(27) Install cab (Para 15-2).
(28) Open cab door (55).
(29) Open engine access door (56).
(30) Remove dipstick (57) from dipstick tube (58)
and wipe with clean wiping rag.
WARNING
Transmission oil is slippery and can
cause falls. To avoid injury, wipe up
spilled oil with rags.
(31) Fill transmission with transmission oil in
transmission dipstick tube (58).
CAUTION
Check dipstick for dirt or other contamination before installing in dipstick tube. Wipe any
contamination away using a clean wiping rag or damage to equipment may result.
NOTE
Forklift should be on level surface to ensure oil level can be checked correctly.
(32) Insert dipstick (57) in dipstick tube (58).
(33) Start engine (TM 10-3930-669-10) and run for
five minutes.
(34) With engine running and transmission in
neutral, remove dipstick (57) from dipstick tube
(58) and check oil level.
(35) Add
transmission
oil
as
necessary
to
transmission until oil level is at the FULL mark
(59) on dipstick (57).
(36) Close cab floor access door (56).
(37) Close cab door (55).
NOTE
Follow-on Maintenance:
•
Remove wheel chocks
(TM 10-3930-669-10).
END OF TASK
8-16
|
