TM 10-3930-669-20 7-47.  BATTERY REPLACEMENT (CONT). WARNING Corrosion     inhibitor     contains alkali.  Do not get in eyes; wear goggles/safety    glasses    when using.  Avoid contact with skin. In case of contact, immediately wash area with soap and water. If    eyes    are    contacted,    flush eyes    with    large    amounts    of water   for   at   least   15   minutes and     get     immediate     medical attention. (8) Coat negative battery terminal (8) with corrosion preventive compound. (9) Install  negative  side  of  cable  (7)  on negative    battery    terminal    (8)    and tighten    nut    (6).        Cover    negative battery  terminal  (8)  with  black  rubber terminal cover (5). WARNING • Battery acid (electrolyte) is extremely harmful.  Always wear safety goggles and  rubber  gloves,  and  do  not  smoke  when  performing  maintenance  on batteries.  Injury will result if acid contacts skin or eyes.  Wear rubber apron to prevent clothing being damaged. • Remove   all   jewelry   such   as   rings,   dog   tags,   bracelets,   etc.      If   jewelry contacts  battery  terminal,  a  direct  short  may  result  in  instant  heating  of tools, damage to equipment, and injury or death to personnel. (10)    Coat negative battery terminal (4) with corrosion preventive compound. (11)    Install negative cable (3) on negative battery terminal (4) and tighten nut (2).  Cover negative battery terminal (4) with black rubber terminal cover (1). NOTE Follow-on Maintenance: • Install right-hand engine panel (Para 15-9). • Close right-hand engine access cover (TM 10-3930-669-10). • Remove wheel chocks (TM 10-3930-669-10). END OF TASK 7-110