TM 10-3930-669-20 4-12.  THROTTLE CABLE REPLACEMENT/ADJUSTMENT (CONT). (3) Position throttle cable nut (14) on cable (13). (4) Install clevis (8) on cable (13) with throttle cable nut (14). (5) Install cable (13) on bracket (5) with clamp (12), two washers (11), and nuts (10). (6) Install clevis (8) on throttle bracket (9) with pin (7) and clip (6). (7) Install plate (2) on bracket (5) with two screws (4) and nuts (3). (8) Install two nuts (1) on plate (2). d.  Adjustment. (1) Adjust cable (13) to obtain .75 inch dimension as shown and tighten throttle cable nut (14). NOTE Position clevis end so that the hole is offset of the throttle lever. (2) Extend clevis (19) past hole of lever (20) a distance equal to the hole of clevis and tighten nut (21). (3) Readjust cable (13) so that clevis (19) hole aligns with lever (20) hole. (4) Install clevis (19) on lever (20) with pin (18) and cotter pin (17). 4-40