TM 10-3930-669-20 4-11.  THROTTLE PEDAL REPLACEMENT (CONT). (5) Remove three nuts (14), screws (15), and washers (16) from throttle pedal assembly (17) and floor plate (18). (6) Remove throttle pedal assembly (17) from floor plate (18). b. Cleaning/Inspection. WARNING • Dry-cleaning  solvent  (P-D-680)  is  TOXIC  and  flammable.    Wear  protective  goggles  and  gloves; use only in a well-ventilated area; avoid contact with skin, eyes, and clothes; and do not breathe vapors.  Keep away from heat or flame.  Never smoke when using solvent; the flashpoint for type I dry-cleaning solvent is 100°F (38°C) and for type II is 138°F (50°C).  Failure to do so may result in injury or death to personnel. • If  personnel  become  dizzy  while  using  cleaning  solvent,  immediately  get  fre  sh  air  and  medical help.    If  solvent  contacts  skin  or  clothes,  flush  with  cold  water.    If  solvent  contacts  eyes, immediately flush eyes with water and get immediate medical attention. (1) Clean all metal parts with dry-cleaning solvent. (2) Inspect all parts for breaks, cracks, burrs, and sharp edges. (3) Replace all damaged parts. c. Installation. (1) Install throttle pedal assembly (17) in floor plate (18) with three washers (16), screws (15), and nuts (14). Tighten screw to 7 lb-in (10 N•m). 4-36