TM  10-3930-669-20 CONTINUITY TEST (1) Set multimeter select switch to OHMS. (2) Check  continuity  between  connector  P17, terminal 3 and a known good ground. (a)   If  there  is  no  continuity,  repair  drive axle   oil   cooler   ground   wire   (see   schematic Appendix F). (b)   If there is continuity, replace drive axle oil cooler (Para 10-2). (3) Connect  connector  P17  to  drive  axle  oil cooler fans connector. (4) Install engine ventilation panel (Para 6-2). (5) Connect  connector  P17  on  drive  axle  oil cooler fans connector. 2-349