| |
TM 10-3930-669-20
CONTINUITY TEST
(1) Disconnect wire 15 from transmission
temperature sensor and connect to
good ground (Para 7-43).
(2) Set MAIN POWER switch to ON
position (TM 10-3930-669-10).
(3) Set engine switch to ignition position
(TM 10-3930-669-10).
(4) Observe gauge needle for reading.
(a) If gauge does not have a full scale
deflection,
perform
Steps
(5)
through (8) below and go to Step 2
of this Fault.
(b) If gauge has a full scale deflection,
perform Steps (5) and (6), below
and
replace
transmission
temperature sensor (Para 7-43).
(5) Set engine switch to off position.
(6) Connect wire 15 to temperature sensor
(Para 7-43).
(7) Set MAIN POWER switch to OFF
position.
(8) Install floor plate (Para 15-12).
2-145
|
