| |
TM 10-3930-669-20
f. Adjustment.
NOTE
Complete loosening of the outer nut
will permit adjustment of the inner
nut.
(1)
Loosen nuts (1 and 17). Nut (1) should be
completely loosened.
(2)
Remove two screws (3).
(3)
While holding bracket (2) in position, gently turn
inner nut (17) until it just contacts bracket (2)
without causing valve stem (8) or cable end (4)
to move. It may be necessary to slide bracket
(2) toward nut (1) to gain clearance to turn nut
(17).
(4)
Hand tighten outer nut (1) against bracket (2).
(5)
Remove pin (7) and cotter pin (6).
(6)
Install bracket (2) on control valve (9) using two
screws (3).
NOTE
Final adjustment requires trial and error.
(7)
If hole in cable end (4) is aligned with hole in valve stem (8), adjustment is complete. Go to Step (9).
(8)
If hole in cable end (4) is not aligned with hole in valve stem (8), repeat Steps (1) through (8) until adjustment is
complete.
(9)
Repeat process for remaining cables.
NOTE
Follow-on Maintenance:
·
Install steering hose to stack valve (Para 17-11).
·
Install instrument panel (Para 7-8).
·
Install oil filter tray (Para 4-13).
·
Install batteries (Para 7-48).
·
Remove wheel chocks (TM 10-3930-669-10).
END OF TASK
17-19
|
