| |
TM 10-3930-669-20
17-2. PIVOT/SHIFT JOYSTICK REPLACEMENT/REPAIR (CONT).
(6)
Position housing (23) on pivot/shift joystick (15)
and install six screws (22), twelve washers (21),
six lock washers (20), and nuts (19).
Tighten nuts to 8 lb-ft (11 N•m).
NOTE
·
Do not tighten nuts on cables of
pivot/shift joystick until they are
adjusted during installation.
·
Pivot control cable assembly is
shown. Shift control cable is
assembled the same way.
(7)
Position two nuts (1) and lock washers (18) on
pivot control valve cable (4) of pivot/shift
joystick (15).
(8)
Position bracket (2) and nut (17) on pivot control
valve cable (4) of pivot/shift joystick (15).
e. Installation.
(1)
Install pivot/shift joystick (15) on dash frame
(16) with four washers (14), lock washers (13),
and screws (12). Tighten screws to 7 lb-ft (10
N•m).
17-8
|
