| |
TM 10-3930-669-10
Table 3-1. Operator Troubleshooting Symptom Index - CONT.
Troubleshooting
Page
Procedure
STEERING SYSTEM
1.
Steering is difficult or does not respond ..............................................................................................
3-10
2.
Forklift shimmies, wanders, or pulls to one side ..................................................................................
3-10
HYDRAULIC SYSTEM
1.
Mast does not operate ........................................................................................................................
3-10
2.
Mast does not pivot ............................................................................................................................
3-10
3.
Mast does not shift ..............................................................................................................................
3-11
3-4. OPERATOR TROUBLESHOOTING PROCEDURES.
Table 3-2 contains the malfunctions listed in the Operator Troubleshooting Symptom Index (Table 3-1), test and
inspection instructions required to determine the cause of the malfunction, and corrective actions for repairing
equipment.
Table 3-2. Operator Troubleshooting Procedures
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
ENGINE
1. ENGINE WILL NOT CRANK.
Step 1. Check MAIN POWER switch position.
If MAIN POWER switch is not in the ON position, set switch to ON position.
If MAIN POWER switch is in the ON position, go to step 2.
Step 2. Check transmission control lever position.
If transmission control lever is not in the neutral position, set lever in the neutral position.
If transmission control lever is in the neutral position, go to step 3.
Step 3. Inspect battery cables.
If battery cables are damaged or disconnected, notify Unit Maintenance.
If battery cables are OK, notify Unit Maintenance.
3-3
|