TM 10-3930-669-10 2-10.  OPERATING PROCEDURES (CONT). (5) Continue pivoting the load clockwise into the rack while the forklift is still moving forward at a slow (creep) speed until the load is perpendicular to the rack (mast assembly parallel to rack). (6) Shift the mast assembly to the right until the load is completely in the rack opening. (7) Lower the forks until the load is completely supported by the rack. (8) Start to shift the mast assembly to the left. NOTE You will notice mast assembly counterclockwise pivot and left-hand shift action at the same time. These functions will not be synchronized and one function may stop before the other. (9) With  the  forklift  moving  in  reverse  at  a  slow  (creep)  speed,  pull  the  mast  assembly  pivot/shift  joystick (Table 2-1, 16) rearward and to the left. (10) When the forks are partially shifted to the left and at an angle of approximately 45 degrees, stop the left- hand shifting motion. (11) With the forklift still moving in reverse at a slow (creep) speed, continue to pivot the forks counterclockwise until forks clear the load.  Continue to pivot counterclockwise while shifting back to the right until forks are centered in front of the forklift. 2-34