TM 10-3930-669-10 2-10.  OPERATING PROCEDURES (CONT). d. Engine Starting. (1) Apply parking brake (Table 2-1, 2). (2) Place transmission control lever (Table 2-1, 5) in neutral position. (3) Turn MAIN POWER switch (Table 2-1, 20) to the ON position. WARNING Ensure  that  all  personnel  are  clear  of  forklift  before  engine  start  is  attempted.    Operator  must visually check to see that all areas of the forklift are clear of personnel before attempting to start engine.  Failure to do so could result in serious injury or death to personnel. CAUTION • Do not turn engine switch to start position while engine is rotating, or damage to equipment may result. • If engine fails to start, wait 15 seconds before next start attempt to allow starter to cool. NOTE If engine fails to start, the engine switch must be turned to the off position, prior to the next attempt. This will disengage an engine restart interlock which prevents starter engagement from the ignition position. (4) Turn  the  engine  switch  (Table  2-1,  1)  to  the  start  position  for  about  15  seconds  or  until  engine  starts. When engine starts, release switch.  Engine switch will return to ignition position. CAUTION If OIL PRESS gauge does not show engine oil pressure within 5 seconds after starting engine, shut down engine immediately and notify supervisor.  Lack of lubrication will damage engine. (5) Check that engine oil pressure gauge (Table 2-2, 3) reads 30 psi (207 kPa) minimum during idle and 30 to 60 psi (207-414 kPa) during normal operation. CAUTION Engine oil pressure gauge should indicate 30 psi (207 kPa) minimum when engine is running.  Lack of lubrication will damage engine. (6) Run engine for approximately three minutes. (7) Perform operator PMCS procedures designated During in the Interval column (Table 2-3). 2-28