Quantcast CLEANING - TM-10-3930-664-24_797
Share on Google+Share on FacebookShare on LinkedInShare on TwitterShare on DiggShare on Stumble Upon
TM 10-3930-664-24 10.  Remove and discard three piston rings (25). 11.  Remove bearing (26) from shaft (6). 12.  Remove outer thrust washer (27), nearing (28), inner thrust  washer  (29),  and  gear  and  bearing  assembly (33) from shaft (6). 13.  Remove bearings (30, 32) and spacer (31) from gear and bearing assembly (33). 14.  Remove outer thrust washer (34),  bearing  (35),  and inner thrust washer (36) from shaft (6). 15.  Remove snap ring (37) from ring groove. 16.  Remove  clutch  end  plate  (38),  six  inner  discs  (39), and six outer discs (40) from shaft (6). 17.  Compress  disc  washers  (43)  and  remove  snap  ring (41) from ring groove.  Remove retainer (42). NOTE Disc  washers  are  installed  as  a  set. Do  not  intermix  with  sets  from  other clutches.  Replace disc washers as a set. 18.  Remove five disc washers (43), wear plate (44), and clutch piston (45) from shaft (6). 19.  Remove and discard seals (46, 47). B.  CLEANING Clean  forward  and  reverse  clutch  gear components in accordance with paragraph 1-24. C.  INSPECTION 1.     Inspect forward and reverse clutch gear components in accordance with paragraph 1-24. 2.     Ensure bleed orifice in clutch piston is clean and free of foreign material. 4-61

Integrated Publishing, Inc.