Press bearings (10, 9) into gear and bearing
assembly (12). Bearings must be flush with face
of gear on both sides.
Carefully install gear and bearing assembly (12)
onto shaft (27). Align gear teeth with clutch inner
discs. Press down on gear and bearing
assembly until fully seated. Do not force this
Install inner thrust washer (8), bearing (7), and
outer thrust washer(6) onto shaft (11).
Press bearing (5) onto shaft (11). Bearing has a
shield in it which must face up.
Using pliers, install snap ring (3) into ring groove
Install new piston rings (1). Grease rings to aid
installation into transmission housing.
Install clutch assemblies (para. 4-20)
END OF TASK