| |
TM 10-3930-664-24
12.
Remove rear bearing (28) from shaft (27).
13.
Using a bearing puller, remove gear (29) and
inner race of bearing (28).
14.
Using pliers, remove snap rings (30) from ring
grooves.
15.
Remove outer thrust washer (31), bearing (32),
inner thrust washer (33), and bearings (34, 35)
from shaft (27).
16.
Remove gear and bearing assembly (36) from
shaft (27).
17.
Remove outer thrust washer (37), bearing (38),
and inner thrust washer (39) from shaft (27).
18.
Remove snap ring (40) from ring groove.
19.
Remove clutch end plate (41), five inner discs
(42), and five outer discs (43) from shaft (27).
20.
Compress disc washers (46) and remove snap
ring (44) and retainer (45) from ring grooves.
NOTE
Disc washers are installed as a set. Do
not
intermix
with
sets
from
other
clutches. Replace disc washers as a
set.
21.
Remove five disc washers (46), washer plate
(47), and clutch piston (48) from shaft (27).
22.
Remove and discard seals (49, 50).
B. CLEANING
Clean first and second clutch gear components in
accordance with paragraph 1-24.
C. INSPECTION
1.
Inspect first and second clutch gear
components in accordance with paragraph 1-24.
2.
Ensure two bleed valves in clutch drum are
clean and free of foreign material.
4-55
|
