TM 10-3930-664-24 WARNING Use    care    when    removing    plug    (11). Plug is under spring pressure and injury can occur. 7. Remove         plug      (11)         from         transmission. Remove and discard O-ring (31). 8. Remove   disconnect   pin   (12),   spring   (13),   and ball (14) from transmission. 9. Remove shift fork to shift rail lockscrew (15). 10. Remove  shift  fork  (16)  and  fork  rod  (18)  from transmission.  Remove disconnect oil seal (17). 11. Using  pliers,  remove  snap  ring  (19)  from   ring groove.  Remove  flange  rings  (20,  22)  and  shift hub (21) from bore. 12. Using  pliers,  remove  snap  ring  (23)  from   ring groove.    Remove  snap  ring  (24)    from  opposite side. NOTE Seal  sleeve  (28)  and  bearing  (27)  may come out with output flange (25). 13. Tap output flange (25) from output gear and rear bearing using a soft head hammer. 14. Remove output gear (26) from transmission. 15. Using a bearing puller, remove bearing (27) from output flange (25). 16. Remove  seal  sleeve  (28)  and  oil  seal  (29)  from output    flange    (25).    Remove    and  discard  O- ring (30). 17. Remove snap ring (23). 18. If seal sleeve (28) and bearing (27) did not come out    when    output    flange    (25)    was    removed, remove   sleeve   and   bearing   from   transmission case.  Remove bearing locating ring (32). 4-50