Quantcast INSTALLATION (cont) - TM-10-3930-664-24_762
Share on Google+Share on FacebookShare on LinkedInShare on TwitterShare on DiggShare on Stumble Upon
TM 10-3930-664-24 CAUTION Use  care   when   installing  piston  and connecting   rod   to   prevent   damage   to cylinder bore. 14. Position    piston    and    rod    assembly    (18)    into cylinder  bore  with  the  word  FRONT  on  piston towards front of cylinder block (19). 15. Push piston and rod assembly (18) into bore until top of piston is approximately 2 inches (50 mm) below top of bore. 16. Pull      connecting      rod      (20)      down         onto crankshaft  journal.    Ensure  bearing  halves  seat on crankshaft journals. 17. lower  bearing  halves  (4)   onto   lower   halves   of connecting   rods   (1).      Lubricate   bearings   with Lubriplate 105. 18. Lightly lubricate screws (3) with oil.  Install lower halves of connecting rods (1) onto upper  halves (2)  using    screws.        Tighten  screws  in  three steps: a. Step 1: 26 ft-lbs (35 Nm) b. Step 2: 52 ft-lbs (71 Nm) c. Step 3: 74 ft-lbs (100 Nm) FOLLOW-ON MAINTENANCE: Install oil suction connection (para.  3-17) Install cylinder head assembly (para.  3-8) END OF TASK 4-26

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business