TM 10-3930-664-24 NOTE Handle  (12)  is  removed  when  selector valve     is     removed     from     forklift.          If reinstalled, removal is required. 5. Remove  handle  (12)  from  valve  spool  (15)  by removing   cotter   pin   (13)   and   handle   pin   (14). Discard cotter pin. 6. Carefully   slide   valve   spool   (15)   out   of   valve housing (2). CAUTION Use   care   when   removing   spool   seals (16) to prevent damage to spool surface. Note  position  of  seals  before  removing to aid in installation. 7. Remove  spool  seals  (16)  from  valve  spool  (15) using a small tip screwdriver. 8. Remove handle bracket (17) from valve housing (2) by removing screws (18). B.  CLEANING Clean   selector   valve   components   in   accordance   with paragraph 1-24. C. INSPECTION Inspect   selector   valve   components   in accordance with paragraph 1-24. D.  REPAIR Repair   of   the   selector   valve   consists   of   removal   and replacement of defective, deformed, or damaged components. E.  ASSEMBLY 1. Install handle bracket (17) onto valve housing (2) using screws (18). 3-160