TM 10-3930-664-24 NOTE End cap bearing is press fit into end cap (7).   Do   not   remove   bearing.      If   either component   is   damaged,   end   cap   and bearing must be replaced as a set. 5  Remove spacer (10), sleeve (11), and spring (12) from push rod (9). 6. Remove piston (13) from push rod (9).  Remove T-seal (14) from piston and discard T-seal. B.  CLEANING WARNING Isopropyl alcohol is flammable. Inhalation of vapors can cause dizziness and  headache.    Contact  with  skin  may cause irritation.  To avoid injury, observe the following precautions: Keep isopropyl  alcohol  away  from  open  flame or any spark (ignition source). -   Keep   at   least   a   B-C   fire   extinguisher   within easy reach when working with isopropyl alcohol. -  Post  signs  that  read  "NO  SMOKING  WITHIN 50 FEET" when working with isopropyl alcohol. -  Ensure  adequate  ventilation.    If  vapors  cause drowsiness, go to fresh air. - If liquid contact skin or eyes, immediately flush affected areas thoroughly with water. Clean cylinder components in isopropyl alcohol.  Allow to air dry. C.  INSPECTION Inspect components in accordance with paragraph 1-24. D.  REPAIR Repair   of   the   accelerator   slave   cylinder   consists   of removal   and   replacement   of   defective,   deformed,   or damaged components. 3-80