B.  CLEANING 1. Clean  components  in  strong  solution  of  laundry detergent and hot water. 2. Rinse components in hot water and air dry. C.  INSPECTION 1. Inspect for cracks and excessive wear in rocker lever  bores.    Inspect  lever  contact  surface  for excessive wear. 2. Using    internal    caliper,    measure    rocker    lever bore.      Maximum   diameter   shall   be   0.75    in. (19.05 mm).  Replace lever if out of limits. 3. Inspect lever support and shaft for damage. 4. Using   external   caliper,   measure   support   shaft diameter.    Minimum  diameter  shall  be  0.746  in. (18.94 mm).  Replace lever  support  assembly  if shaft is out of limits. D.  REPAIR Repair  of  the  rocker  arm  assembly  consists  of  removal and  replacement  of  defective,  deformed,  or  damaged components. 3-52